The tOOchop® technology uses two blade roll’s in one chopper without the requirement for a stressroll. This technology enables to cut Glass and Carbon fibers with low tex and K value and/or is used when direct roving is applicable. It is possible to cut fibers with extremely bad chopping behavior.
Below you find the machines that use this technology. Choose the type that fits your requirements.
tOOchop® TC
The tOOchop® TC is best suited for
- Fiber: Glass (direct roving), Carbon
- Industry: Automotive & Aerospace, Construction, Raw materials, Research
- Capacity: Mid-range
tOOchop® LD
The tOOchop® LD is best suited for
- Fiber: Glass (assemled roving)
- Industry: Construction
- Capacity: Mid & High-range
Chopcot® SK
The Chopcot SK is best suited for
- Fiber: Polymers (Aramid, Dyneema, Thermoplastics (PP/PA/PE), etc.), Glass, Steel
- Industry: Automotive & Aerospace, Textile, Consumer products
- Capacity: Low & Mid-range
tOOchop® SL
The Chopcot SL is best suited for
- Fiber: Carbon, Basalt
- Industry: Automotive & Aerospace, Raw materials (recycling)
- Capacity: Mid-range
tOOchop® DTC
The Chopcot DTC is best suited for
- Fiber: Glass (Dry Chop, Direct Chop, Inline Chop), Carbon, Basalt
- Industry: Raw materials
- Capacity: High-range
tOOchop® WTC
The Chopcot WTC is best suited for
- Fiber: Glass (Wet Chop)
- Industry: Construction, Raw materials
- Capacity: High-range